Struct atsamd51n::sercom0::i2cs::ctrla::R

pub struct R(_);

Register CTRLA reader

Implementations

impl R

pub fn swrst(&self) -> SWRST_R

Bit 0 - Software Reset

pub fn enable(&self) -> ENABLE_R

Bit 1 - Enable

pub fn mode(&self) -> MODE_R

Bits 2:4 - Operating Mode

pub fn runstdby(&self) -> RUNSTDBY_R

Bit 7 - Run during Standby

pub fn pinout(&self) -> PINOUT_R

Bit 16 - Pin Usage

pub fn sdahold(&self) -> SDAHOLD_R

Bits 20:21 - SDA Hold Time

pub fn sexttoen(&self) -> SEXTTOEN_R

Bit 23 - Slave SCL Low Extend Timeout

pub fn speed(&self) -> SPEED_R

Bits 24:25 - Transfer Speed

pub fn sclsm(&self) -> SCLSM_R

Bit 27 - SCL Clock Stretch Mode

pub fn lowtouten(&self) -> LOWTOUTEN_R

Bit 30 - SCL Low Timeout Enable

Methods from Deref<Target = R<CTRLA_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRLA_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CTRLA_SPEC>> for R

fn from(reader: R<CTRLA_SPEC>) -> Self

Converts to this type from the input type.