Struct atsamd51n::ac::compctrl::R

pub struct R(_);

Register COMPCTRL[%s] reader

Implementations

impl R

pub fn enable(&self) -> ENABLE_R

Bit 1 - Enable

pub fn single(&self) -> SINGLE_R

Bit 2 - Single-Shot Mode

pub fn intsel(&self) -> INTSEL_R

Bits 3:4 - Interrupt Selection

pub fn runstdby(&self) -> RUNSTDBY_R

Bit 6 - Run in Standby

pub fn muxneg(&self) -> MUXNEG_R

Bits 8:10 - Negative Input Mux Selection

pub fn muxpos(&self) -> MUXPOS_R

Bits 12:14 - Positive Input Mux Selection

pub fn swap(&self) -> SWAP_R

Bit 15 - Swap Inputs and Invert

pub fn speed(&self) -> SPEED_R

Bits 16:17 - Speed Selection

pub fn hysten(&self) -> HYSTEN_R

Bit 19 - Hysteresis Enable

pub fn hyst(&self) -> HYST_R

Bits 20:21 - Hysteresis Level

pub fn flen(&self) -> FLEN_R

Bits 24:26 - Filter Length

pub fn out(&self) -> OUT_R

Bits 28:29 - Output

Methods from Deref<Target = R<COMPCTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<COMPCTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<COMPCTRL_SPEC>> for R

fn from(reader: R<COMPCTRL_SPEC>) -> Self

Converts to this type from the input type.